Interested to Buy Any Domain ? << Click Here >> for more details...
what will happen if we inject diesel in petrol engine and
petrol in diesel engine.
- 11 Answers
- 15532 Views
- I also Faced
- E-Mail Answers
Answer Posted / bhatti
engine chokes
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
plz send me the aptitude test paper for hpcl.
How to handle production department ?
Mention two types of dislocations.
what is the minimum velocity of cooling water for maximum efficiency of condensor.
tell about a type when u had to use ur presentation skill to influence someone's.
For hot water : please compare to solar heat and heat pump (environment/operation/invest...) Is there any comparison available. Thank you
sir i am selected for HAL Ast. Engg so pls Interview Qus
Explain mechanism of fatigue failure.
what is the reson in a/c system that TPN TRIPPING
What is meant by newtonion and non-newtonion fluids?
What are the procedures of starting of diesel engine?
What are materials used for manufacturing of gears ?
please send me model question papers for DVC Examination diploma mechanical
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
Explain the causes of the exhaust valve leakage.
