Interested to Buy Any Domain ? << Click Here >> for more details...
What is the cause for a blown fuse in one phase of primery
side(HV) of a three phase transformer( 4169v-460v) in the
time of closing its supply breaker.
There is no load on the secondery side of the transformer
in this moment.
- 3 Answers
- 13563 Views
- Novachem, I also Faced
- E-Mail Answers
Answer Posted / pillay
It could be just high inrush current,
incorrect fuse size or a defective fuse
in the first place.If it recurs than
further investigations should be taken.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
although ckt breakers have taken the place of old fuse. But instead of it , these older ones are still used in the industries and homes ? why .... what are their advantages and disadvantages ? which one is leading and winning the race and competition ?
How to know vacuum in vacuum cylinder of breaker in working condition
how to calculate the distance relay faulty zone?pls explain?
what are safety measures in /control in diesal engine/ explain them?
Why r u using pf panel. what the uses
What is meant by system?
What is the type of feedback used in an op- amp schmitt trigger?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
how is find out kwh step by step
Difference between drift current and diffusion current?
sir& friends i want the collection of recent quetions asked in interview of top most companies please send me on my email san.jsr@hotmail.com
Why is it prefer to initiate circuit breaker failure by "86" lockout relay not by "94" tripping relay ?!
We have 90mX100m hangar with 16 no.of supporting pillar. It is required to provide power supply on all pillars. what is suggested earthing scheme for hangars.
why do we use 25kv supply for traction purpose?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
