Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between an axle and a shaft?
reply soon frnds........
- 11 Answers
- 40884 Views
- I also Faced
- E-Mail Answers
Answer Posted / nitin jain
axel is used to support two or more rotatery members, but
shaft is used to transfer motion from one member to
another ...
| Is This Answer Correct ? | 27 Yes | 3 No |
Post New Answer View All Answers
What is the date of first titan launch from cape canaveral?
What type of cross-section is usually of a chisel?
can any one pls refer me any sites which have notes regarding Body-in-white(welding fixtures)...pls
What is the coefficient expansion of transformer oil?
WHAT IS A TR REQUIRED IF AIR FLOW 6500 CMH COIL INLET TEMP 7 - 12 DEGREE C AIR TEMP INLET - 18 DEGREE C & REQUIRED TEMP IS 12 DEGREE C
CAN ANY ONE SEND ME THE RRB SECTION ENG. Q-PAPER .. MY MAIL ID :suresh25siva@yahoo.com, suresh.sivakumar@tcs.com
22216 CC bearing
aptitutude and technical questions asked in HPCL MECHANICAL ENGG TEST PAPER. IF ANY ONE HAS SAMPLE PAPERS .PLEASE SEND ME ON MY E-MAIL ID . goyal.nirmal@gmail.com. plz
What is NPSH of Pump
Dear Sir, I am Shariq Sami. I joined BHEL as a Supervisor Trainee in May 2009 on diploma basis, right now i am an assistant Engineer and posted at Noida. I have completed my bachelor of engineering from Jamia Millia Islami, New Delhi.I am Planning to appear for "BHEL ET" exam this year. I want to know,is there any previous year question papers will be available like we have for GATE exams or you feel it is no need? Can you please guide me? Kind Ragards M.S Sami, Contact No. 9891090742, 9250250988, 0120-2545796
What are the properties of fuel oil?
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
How do you define mechanical efficiency in case of compressor? How it is different that of an IC engine?
In a rankine cycle if maximum steam pressure is increased keeping steam temperature and condenser pressure same, what will happen to dryness fraction of steam after expansion ?
What kind of materials should be used for shafts manufacturing?
