1. Why transfomer reting in KVA and Motor in HP
Answer Posted / sekar
for transformer we can connect any load(R,L).so its power
factor variable . so it is in kva...
since motor is a load .It is designed for particular power
factor.
Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
How to calculate cable rating for 3 phase supply?
any earth foult trip the relay but in welding time not trip by earth foult
we have a rewind motor of 2Hp,2800Rpm, 220Volt AC. how can we choose the running capacitor for this motor, any formula for that?
what is the purpose that we use PLC system in power system
What is a feedback in control system?
CAN CU XLPE/PVC CABLE BE USED INPLACE OF LOW NOISE SCREENED CABLE? KINDLY GIVE REASONS
why asa method ZPF method is more accurate than ASA method?
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
how many current required for hypo test
In radial network the source is fed from 1 end both ends at central
What is sink and source?
what is the k var ratting of 1250kva
What type of fittings and electrical accessories can be install in radiation area ?
What is the difference between amorphous core transformer and CRGO core transformer?.
IF % IMPEDANCE OF A TRANSFORMER IS INCREASED FROM 5.8% TO 8% HOW MUCH THE EFFICIENCY OF THE TRANSFORMER WILL COME DOWN?