Why we use 4 to 20 mA, (This is International Standard)
instaed of this can we use 4-16, or 4-24 or 3- 15 or any
other range
Answer Posted / dhaval joshi
for any active ckt make it standard 1 volt dc
actually formula is 20-4= 16 then
16/1000*250=4 ma
32/1000*250=8 ma
48/1000*250=12 ma
64/1000*250=16 ma
80/1000*250=20 ma
by using 250 ohm resistance and standard 1000 ma it give
standard voltage.
Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
What are the materials available to prepare individually for competetive exams in Instrumentation field? Plz reply...
Why flow/pressure transmitter before control valve?
How to decrease opening & closing time of on/off valve?
how to measure oxygen which methods are using?
Make Heater Process Logic.
key phaser where is use and work
Explain bernoulli’s theorem. State its application.
how to calibrate corollaries (Mass flow meter)?
hi friends,im an instrumentation and contol engg student,can u hlp me of suggsting barc written question paper,my id is roysuvaranjan@gmail.com, cel no.9563591747
How ejector(or)evactor air pump is working in thermal power plant?
What is intrinsic safety mean.
What is modbus?
What is standard procedure of manual mapping in Radar type level transmitter?
how to commission furnace ( water heater)
Im having problems with interfase betwen SPI v7.0 and SPPID v5.05. Previous versions of Intools shoul be fixed with SPPIDproj.ocx file. It was necessary to replace this file with one that allows the connection between different versions of SPPID. It is necessary in the current version to do the same?Thanks