Answer Posted / ronit
kw is unit for total power
kva is unit for real power
and unit for reactive power is kvar(VOLT AMPERE REACTIVE)
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
why the neutral line is not giving shock to us if we touch it ?
A cable with concentric PE conductor must be used with frequency converter circuits what does its means.?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
do you have some of interview Questions in power and genrator section in general whith answers
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.
How many capacitors using in LT panel as per Govt rules?
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
What is the difference IN MCCB's between thermal magnetic and electronic tripping system ?
hi, i finished b.tech eee in 2008, im worked in dg sets mfg company , now i left job in 6months back, now again i want get job core side, how can i get? is there any couses we have learn to get better oppurtunity? /
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
how we arrange the hv side with delta connection in case 33/11kv of transformer.
Why compensation is necessary in feedback control system?
What is the lower limit of break-down voltage of converter transformer.
