Interested to Buy Any Domain ? << Click Here >> for more details...
what will be fault level of 11 KV , 2000 A ELECTRICAL
SYSTEM?
- 4 Answers
- 7725 Views
- I also Faced
- E-Mail Answers
Answer Posted / ranjan maithan
fault level depends on your system's percetage impedance.In
general practice we are using 28KA for 3 secs. or 40KA for
3 secs.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
which motor have relatively high power factor and what is reason for have high pf? 1.capacitor run motor 2.shaded pole motor 3.capacitor start motor 4.split phase motor
what is meaning of bus riser
How to test the Secure Elite 440 Multi function meter working condition.
Difference between HRG and NGR. Are they both the same thing
EXPLAIN USE OF ROCKING ARRANGEMENT IN ELECTRIC HEATING?
pls someone send me sample question papers along with the key.thanks in advance
Difference between ac parallel circuit and ac series circuit?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
Please explain me about Relay curves and their sources to read ?
What happens to voltage when current through the inductor is constant?
pls,send the previous year written test questions.
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
what may the reason for vector shift in a generator?
How can we calculate the efficiency of a Running (On-Load) Motor ? What parameters are required and what is the method ?
What is the difference between resistance grounding system and resistance earthing system?
