what is the function of Droop CT and where it is used?
- 3 Answers
- 33675 Views
- Lanco, I also Faced
- E-Mail Answers
Answer Posted / l.l
Droop CT is used to control load sharing of the reactive
power between paralleled generators. Its output is mixed
with the phase voltage to result in a signal that will be
proportional to the lagging power factor. This is used to
adjust the excirtation current accordingly so that the
proportion of reactive power is shared between them.
| Is This Answer Correct ? | 75 Yes | 3 No |
Post New Answer View All Answers
orifice sizing how done, checking & selection
What will happen if the armature resistance is in minimum position and the field resistance is in maximum position while starting the motor
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
what kelvin's law ?
Define closed loop control system.
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
What is the difference between the relay and the circuit breaker?
why don't we use the generator as a motor? and what will happen?
features of hbc fuses
draw the block diagram of fire alarm?
why industry prefer ht motor instead of lt motor.
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases flux A does not alter B decreases C increases D none of above
When lag/lead/lag-lead compensation is employed?
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
what is protection class current transformer.
