Hello sir
This is prakash from
bangalore i have a doubt why we have to
maintain DG power factor in the range
0.78 to 0.8
Perhaps i f it is increased means what
will happen in DG
- 3 Answers
- 4783 Views
- I also Faced
- E-Mail Answers
Answer Posted / meenakshi
if power factor goes beyond 0.8 (say 0.9), your dg will be
over loaded and may trip or call for frequent overhauls.
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
Why efficiency of generator is higher than motor at a particular load?
how does WTI work ?
Please sent me some previous year question papers of BSNL-JTO telecom and RRB in ELectrical Engineering to varshashahi@yahoo.com
what causes contact chatter when there is no demand on the air conditioning unit?
for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?
What is the effect of positive feedback on the stability of the systems?
Why is a synchronous motor always star connected??
Give me the calculation steps to design an electromagnet to be work in 230V 50 Hz AC Supply. Also give force that is created by that electromagnet when it gets energized.
What do you understand by oldham's coupling ?
is it possible to turn on the single phase star delta on delay timer using 24 v dc ?
What are the various types of rotor used in the alternators?
What is difference between Harmonic and Non harmonic Capacitor Bank?
What is the difference between a fuse and a breaker?
is it true there's a big difference in using Cummins or Denyo...especially power output or leakage
what shall be no load voltage of 132/33 kV transformer ? is it 33 kv of 34.5 kV
