Interested to Buy Any Domain ? << Click Here >> for more details...
give me the mix proportion for design mix concrete M10 grade
1:4:8
- 13 Answers
- 65435 Views
- Gammon, IOCL, PSL, SDG, Simplee, STUP Consultants Pvt Ltd, I also Faced
- E-Mail Answers
Answer Posted / orient builders
1 4 8 means cement sand (fine aggregate) metal 20 mm (coarse
aggregate)respectively.
The ratio is based on volume and not in weight.
one bag of cement is 1.25 cubic foot
Therefore multiply the fine and coarse aggregate with 1.25.
Thus you have to use 1.25 cft of cement (one bag) and 5 cft
of sand and 10 cft of coarse aggregate.
As for sand is concerned bulkage allowance is to considered
according to which the quantity may slightly vary
| Is This Answer Correct ? | 23 Yes | 4 No |
Post New Answer View All Answers
why does the most of civil engg is not intersted to going for teaching field?
for pretensioning which will yield first and same for post tensioning?
What things architect have to take care of before starting any project?
What is the difference between EPC,DBOOT and BOOT.
What is the Unit weight of coarse sand (F.M- 2.20) ?????
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
Which is the direction of negative angle?
what is the minimum reinforcement provided in beams,footings,slabs? what is the minimum soil bearing capacity to design a multistorey building
what should be the PCC ratio to construct a plinth of (40x40x4)ft...??also its estimated cost??
what is diversion?
What is the quantity of cement used for stone pitching work of 100sqm 225mm thick and cement mortar of 1:6? And how?
How does a traffic light signal work ?
If we have the center line of the Finnish road level and we want to know what level of pay would have offset the Lhs and Rhus RHS 1,2.5,5 1,2.5,5 m.
roll of DLC in road constructions
pls mail some more tecnical qustions at msaranya2610@gmail.com
