Interested to Buy Any Domain ? << Click Here >> for more details...
hoe to select the cable size in sq mm for certain load?
- 5 Answers
- 10346 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / rajesh kumar
We can select the cable size in sqmm for certain load by
this process
Cross sectional area of conductor in sqmm
In single phase=a=2x4.59PL
Where a=crosssectional area of conductor
P=Load in KW
L=Distance of load point
In three phase=a=4.55xPL/3
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
why actual valve timing diagram is different than ideal valve timing digram of a 4 stroke engine?
what are the specifications we must look at to select a relay for any capacity motor?
Give idea about General Engineering. From which book i can study this topic. Pl. reply me via email. My email is ravi@bhelhwr.co.in, also give the name of book/website, from where i can prepare it.
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
I want to ask that is there any relation between current denesity of copper and material purity. also is ther any standard which defines the standard current denesity of material.
which type of cabel
sir, 3phase induction motor takes different pf and different KW in three phase while running,explain reason
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
How do I calculate/select Droop CT ratio for various capacity of generators?
What is the maximum percentage voltage drop (vd%)for a motor control center
ACB & VCB how do work and saftes and how can maintenance in this and parts name show with picture
why did youi choose this career?
what is ps impedance test
Haw to check conductivity of budbar
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
