Interested to Buy Any Domain ? << Click Here >> for more details...
CORRECT INFORMATION ABOUT TRANSFORMERS,what actually
transformer is?
- 6 Answers
- 7786 Views
- I also Faced
- E-Mail Answers
Answer Posted / sajid
transformer is a static device which is sed to transfer
energy from one side to (primary to secondary) without
change in frequency. transformer is of two types step up n
step down.
step up transformer is used to increase low voltage to high
voltage n step down transformer decrease from high voltage
to low
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What is the power factor of an alternator at no load?
i applied for c licence with my one year apperents trainee and i have attaced with A grade contractor company experiance that is for 14 monts experiance this document is sufeicant for c licence? pls tell why they rejected
A double circuit with dog conductor 66KV Transmission line from wind farm evacuation to feeding substation having capacity of 25MW for transmission. Can same transmission network be considered for further expansion of Power & how much in MW. If we need to expand next 10-15 MW more will there any augmentation is required in transmission network? Kindly reply asap.
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
What happen when change order of CT in GIS feeder?
The SFC of an engine is 0.25 kg/kW hr. when the fuel used has a calorific value of 36000 kJ/kg. the thermal efficiency of the engine is
how the characterstics of control valve being done
what are the types of electromagnetic forces developed in practical transformer?
What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?
Why computer humming sound occurred in ht transmission line?
should %impedance be high or low in a power transformer? if so why?
What is the difference between acs 550 & acs 850
Why does the rotor rotate?
What if high voltage side circuit breaker of a ehv transformer instead of lvcb? Kindly elaborate.
