Interested to Buy Any Domain ? << Click Here >> for more details...
In a Circuit how the MCB and Fuse ratings are calculated.
And shall the fuse follws the MCB or it is otherwise?
- 16 Answers
- 92954 Views
- Emerson, HCL, Thirumalai Chemicals, I also Faced
- E-Mail Answers
Answer Posted / srihari
first we have to calculate the total load according that we
can use the formula whether it is single phase I=p/V cos(i)
or 3phase I=(P*L.F)/(1.732*V*cos(i))
for example if we get the value 20Amps, so we should choose
near to that value of rating MCCB(32A)
| Is This Answer Correct ? | 14 Yes | 3 No |
Post New Answer View All Answers
Operation carried out in thermal power stations?
how can tell us the AC indoor or outdoor which Tr and formulls
How many gap between finger contact in a.c.b. and v.cb.?
difference between the applicability of nortons and thevenin theorem
Why neutral point is consider as zero potential?
Is there any specialised book to refer about fault level calculation both in MV and LV side??
If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
How should i design a 1ph & 3 ph transformer. Kindly let meknow all steps and formulaes related to design from scratch.
How many types of probe used in cro?
How to do fabrication , busbar and wiring cost for : 1. LT Panels 2. C& R Panel
Why 1/3 is used in symmetrical components?
What is synchro?
A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
