what is the difference between 3,4 wire RTD sensor?
Answer Posted / centhile r mohan
the difference between is that,the third wire for 3 wire
RTD is used for lead compensation.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
can you provide me full detail about instrumentation in ONGC??
Make Heater Process Logic.
what is the difference between profibus and controlnet networking.
how to calibrate steam control valve in steam turbine
what is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
how to work MIL contol valve posistioner ?
what is compensation? temprature & pressure
Calibration procedure for Electro magnetic Flow meter
Meaning of the following a. IOP- Manimum; b. IOP- Maximu,;
how to relay switch sense the fault?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
what is zero and span ?
Hi i am aneesh, done btech in applied electronics & instrumentatiin. And then i took mba in finance & marketing.After that i got placement in finance co and worked there for 3.5 yrs.Now i wanted to come back to engineering job.But without engg experience, i may not able to find an opening.i have done a course related to flow meters and ite calibrations. Kindly suggest where should i try to get a job?
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
draw the block diagram of a level transmitter ?