Why DP level transmitter preferred for closed vessels and
Radar level transmitter for open tanks??
- 2 Answers
- 7234 Views
- I also Faced
- E-Mail Answers
Answer Posted / vaishnavi
In the case of closed tank der will pressure acting above the liq also.So in this case inorder to get accurate measurement we need to measure both pressure so we use dpt.But in the case of an open tank there will atmospheric pressure above the liq surface.Hence we need not measure pressure above liq.moreover as radar involves reflection principle this cannot be used to measure both the pressures in the closed tank.
| Is This Answer Correct ? | 4 Yes | 7 No |
Post New Answer View All Answers
The company where I am working, their is rosemount 5400 series radar type level transmitter, it is meant to show level of filled tank, but along with the level it is showing temperature also, so my question is how a onon-contact type radar type level transmitter can show temperature even if it does not have any contact with the fluid?
Calibration procedure for electro magnetic flow meter
Galvanizing.
How to calculate P,I&D value in PID controller ?
plz tell me clearly about PID.."when v have to change I value,D value,GAIN??
How does temperature bath work? How does coil gets heated only by applying some current?
List three types Level Switches with their working principles
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
How RAL(Rotary air lock)works in cement industry?
Explain about the leakage class of the control valves
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
please someone tell me what is function of vibration sencer and how many types and how to control viberation.please. my id is jimmykhan077@gmail.com
Which type of pressure can be measured by these elements?
What is Positive Calibration and Negative Calibration?
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
