Interested to Buy Any Domain ? << Click Here >> for more details...
I have a thermal flask in which i have to fill the boiled
water.
I also have thermocol, saw dust and silver paper.
Now tell me how i have to arrange these material to attain
minimum
heat loss.
- 7 Answers
- 9187 Views
- I also Faced
- E-Mail Answers
Answer Posted / abhay
for minimising heat losses we should always keep the material with least thermal conductivity ie. highest thermal reistance at the outer most layer and material with highest conductivity
at the imner side sothe correct order from inside is
0>thermal flask
1>silver plate
2>saw dust
3.thermocol
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Name the strongest and weakest type of atomic bonds?
I got i20 for university of bridgeport,university of new heaven and eastern michigan university.Please tell me visa success rate for these universities.And I want to go to Connecticut.At that place two universities are avaliable one is new heaven and the another one is bridgeport.Which is the best? Please give reply as early as possible.
Describe transfer machines?
what will be the minimum bearing clearance that after it will not profitable for machines?
how much efficiency loss will tool place in a steam turbine due to low vaccum?
Why cavitation will occur in centrifugal pump and not in displacement pump?
why we are using mineral wool as insulation material than glass wool , in india?
Explain the difference between upstream and downstream in a refinery?
What are the items to inspect after cylinder liner is pulled out
What type of job are you holding at the moment? What is your desired employment / occupational field
purpose of primary and secondary air? causes of smoke?
i am preparing for vsp management trainee technical 2010.can any one send me modelpapers of preliminary written test.
What is the difference between upstream and downstream in a refinery?
sir, can you give me full idea for computational fluid dynamices and how can work in CFD
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
