Interested to Buy Any Domain ? << Click Here >> for more details...
why we use 0.2 to 1.0 kg/cm2 output in control valve
- 4 Answers
- 14586 Views
- GNFC, I also Faced
- E-Mail Answers
Answer Posted / guest
0.2
| Is This Answer Correct ? | 1 Yes | 6 No |
Post New Answer View All Answers
what is maxdna ?. explain about the software details.
Why plc require in analog input 4-20amp & 0-10 volt?
can anyone tel the syllabus or previous year question paper for BHAVINI(EIE)2014.
what is KV and XV valve
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
What is the PLC configuration in Cement industry?
How many interlocks at turbine side?
how can use ram
what is interface level and how it is calibrate?
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
hi! i want to know about mpse exam.
how to calibrate electro pneumatic positioner 8013 mil controls ltd ?gsr
How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)
Speedtronic system .
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
