Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate cable size for a particular load? i have 12
MW,11KV Motor 3 Phase, what should be cablesize?
What are the points to remember for cable sizing calculations?
- 2 Answers
- 6599 Views
- I also Faced
- E-Mail Answers
Answer Posted / manoj
Calculate steady state voltage drop and motor starting voltagedro they should be within limit also the short circuit withstand capacity to satisfy i2t
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
How to determine the breaking capacity such as break down current and break down voltage for VCB and CT's.
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
why we use two slope(differential & restraining) in differential relay.but in busbar protection differential we are using only one slope?please explain
Define what is difference between fuse and breaker?
How to calculate the current of Highpressure Mercury Vapour Lamp?what is the basis?whether we have to consider power factor or not?
CAN ANYBODY PLEASE TELL ME HOW TO DESIGN A SERIES REACTOR FOR LIMITING SHORT CIRCUIT FAULT CURRENT??
Either the Armoured Earthing strip of HT 3 core cable have to pass through CB CT or not , why ???
what you have to see after one week or month from the day of installation of transformer ?
SIR, GIVE ME OPGW SAG CALCULATION FORMULA I AM DAE ELECTRICAL. THANKS
What is the main cause of magnetism?
Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.
how to calculate the settings for shaft ct protn in hydro generators
if main CT is of ratio 50/5, and meter CT is -/5 what will be overall multiplying factor of meter.PT is 11000/110 .
How to calculate ant test the burden of Current transformer
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
