Which one is the main bar in a square slab (2m x 2m)
- 7 Answers
- 12804 Views
- I also Faced
- E-Mail Answers
Answer Posted / vijayakumar
Bottom bar
| Is This Answer Correct ? | 17 Yes | 3 No |
Post New Answer View All Answers
what is the weight of 10mm,20mm,40mm aggregate
How many square meter can mason layout chb per hour
How does a traffic light signal work ?
What is c.g.i sheet which used for roof??
What are the different types of runners?
What the advantages and disadvantage of using 90mm and 100mm bricks for a wall of a house? Thanks for any input.
crank types
strength of bitumen concrete with 80-100 & 60-70 grade bitumen
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
what is the water cement ratio? how to calculate it? list the wt. of constructions materials including concrete both ordinary and light wt. concrete
Design a cantilever type retaining wall to retain sand for 4m above the ground. The sand fall slopes at the rate of 1 vertical to 2 horizontal. The weight of sand is 18000 N/m3, the angle of repose being 30. The safe bearing capacity of the soil is 200 kn/m2 at 1/25m below the ground level. Use m 15 concrete mix.
Explain the different types of building contracts?
Reinforced concrete: suppose you are doing rough estimate for purchase of rebar for reinforced concrete slab for single stores residential building. You know total concrete volume will be 100 m3. How many tons rebar 6, 10 and 12mm will you require for the project?
what is the Purpose of Adding 20% of wet mortar & 1/3rd to Dry Mortar for PCC & Plastering & Rcc .is there any standard method for adding this .?
I Want To Know Quantity of Cement Conc. & Sand in Column of 9"x9"x10'
