Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / g.n.d.kennedy
I think, my friends are correct. However, the following
problems shall be consolidatively considered which would
occur for motors.
1. OVER VOLTAGE
2. OVER LOAD ( that is over curren resulting over heat}
3. disconnect of either one or two phase in case of 3 pahse
motor
4. Phase sequence reversal
5. Over speed
6. Earth fault
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
How phase to phase voltage comes 440V.
what is a bus riser in power system and why it is used
1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to confirm its base capacity?
how the CT and PT is connected in the circuit during testing of transformer explain with diagram
how pt is using
please send me previous year questions of jspl through which i could prepare myself for the test.
How to calculate wire length,size & current? ( related to control panel)
Can anyone provide with a SLD for HT panel installation for a 33KV line and distribution end has three 1.5MV transformers. Is it suitable to use OCB or VCB and also provide me the suitable rating and its connection diagram.
How to address the servo drive for motor
i want to run 11kv star connected motor in 6.6kv with delta connected throught inverter, is it possible?
what is the most permissible winding temp when we conducting a generator load test?(condition no load)
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
What is power factor why we should maintain the power factor unless what will happen
How to decide and select the different earthing wire size for the different types of earthing
What is the method of estamating of cable, CB,MCB ?
