Interested to Buy Any Domain ? << Click Here >> for more details...
compare the thermocouple and pyrometer,which one is the best?why?
- 4 Answers
- 17958 Views
- Ramco, I also Faced
- E-Mail Answers
Answer Posted / raju
Both as its own application and its useage
t/c can measure only upto particular range only depending
on the type of t/c were as pyrometer range will be more
than t/c, at the measuring range of pyrometers t/c will
melt more over for temp. between 1100deg its lots better to
go for t/c only if the contact is available and the range
above this its better to preffer pyrometer wether it may be
contact r non contact is available
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
Describe a time when you anticipated potential problems and developed preventive measures.
I will attend an interview with GasGas company for a position of Instrument Technician ( Offshore )in next month can anyone tell me what questions they will ask. Thanks in advance.
what is span value and zero ? and how set ?
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
if my flow is 20000 m3/h than which range of DPT i have to use????
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
Sir,I am going to sit for IOCL written test exam. recently.Can anyone tell me the name of 'Objective type Question Book on Instrumentation Engineering ' which will help me. Pl. mail to bidyut_71@rediffmail.com / bidyut.saha2008@indiatimes.com / bidyut.saha09@yahoo.in
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
What do you know about gail?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
Q- Control problem are mainly classified in _____ types. a-)4 b-)3 c-)6 d-)nono of these Few of them i know is 1- regulator type problem (eg- Air conditioner) 2- tracking problem (eg missile trcking problem) 3- sybernatics 4- optimal control problem
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
field bus transmitter calibration procedure tell me
If fire would be inside the plant which fire detector is to detected the fire.
WHAT IS THE CAM POSITION IN CONTROL VALVE POSITIONER ? WHY IT IS USED?
