Interested to Buy Any Domain ? << Click Here >> for more details...
Why all voltage level are multiples of 11, like 220V, 440V,
1100V instead of 200V, 400V, 1000V?
- 9 Answers
- 21541 Views
- Indian School of Mines, I also Faced
- E-Mail Answers
Answer Posted / girish
AC sine wave form factor will be of RMS value / Average value
of a sine wave, that will be 1.11, so all voltage levels are
multiples of 11
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
what is ic 01,ic 06 ?is it types of cooling?
How to select cable the size, what is the parameters use and what is the formulas use for this cable size calculation?
State and define ohm’s law?
how does a shunt reactor maintains the bus voltage???
Discuss about gear cutting machines.
if we have 320KVA Genset kindly advice how much load we can put it.
Difference between megger test equipment and contact resistance meter test instruments?
i have a 1500kVA transformer what is the kWH meter i need to use?
what do w do when the output of generator is fluctuating?
why we permissive overreach in distance protection.where it is applicable to use in long r short lines
what happen if the parallel generator phase angle shift by 1 degree in manual mode
WTA used cb?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
which type of motor is used in automatic swing gate
