Interested to Buy Any Domain ? << Click Here >> for more details...
i have one temperature TX in my loop check time once i was
remove elament temp gose maximum then i am conect corectly
but still now temp showing maximum what can i do this
problem?
- 2 Answers
- 5069 Views
- I also Faced
- E-Mail Answers
Answer Posted / rkb
your xmtr is in the state of Hi alarm latched. and it can
reset once you switch off the power supply(24VDC).
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
1.can you use SCADA instead of DCS,DCS instead SCADA 2.Difference between DCS and PLC,can their role be reversed i.e. role interchange 3.Difference between RTU and PLC
Gas equation
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
if in a level tx height is given, how u calculate the ranges of the tx?
A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer
What is the PLC configuration in Cement industry?
give me the formula for analog to digital converter and also d to a converter
how to calculate control valve bonnet size?? or how to select its material?
What is modbus?
why using negative supply for bentley nevada vibration system ?
How to calibrate the flow transmitter
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
How to Calibrate Interface Level Troll in field
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
