Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / chelladurai.p
The basic function of switch gear is to control the supply
of Electric power and protect the equipment in the event of
abormal condition
| Is This Answer Correct ? | 33 Yes | 3 No |
Post New Answer View All Answers
WHAT IS VCB SAFETY
when generator short circuit condition, the current how dissipates. or at short circuit voltage not available then current how can flow?
IN electrical field, WHAT ALL THINGS THE CUSTOMER WILL ASK WHILE ORDERING FOR LT PANEL (ALL TYPES OF LOW TENSION PANEL)
Describe Non I.S. Earth System and why is it used?
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
The metal-enclosed switchgear and controlgear is subdivided into three types: 1. metal-clad switchgear and controlgear; 2. compartmented switchgear and controlgear 3. cubicle switchgear and controlgear. What is the main differnence between them. State some example.
in 6.6 kv vaccum circuit breaker vaccum bottole vaccum capacity ????
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
Why r u using pf panel. what the uses
On a 6 KVA UPS we have to provide a DC MCB for Battery bank of 16 nos (12 V 42 AH). What Shall be the current rating of DC MCB ?
when ac current flows thru d coil of a contactr,it energizes,magnetic field attracts d contact of the coil...nw wont dt ac current in d contct induce current back on to d coil thru mutual inductance leading to high currnt in d coil
why 1.7Uo for HV cable Hi pot test?IE standard why?
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
sir please send me previous year questions of jspl of electrical section through which i could prepare myself fpr the test.
