different between circuit breaker & switchgear & relays
Answer Posted / maheskumar
relay is an protecting device it protect only an particular
connected line
circuit breaker mostly used in transmission so it protect
against high voltage line any fault contition circuit
breaker trip the line and protect the device
switch gear it can be used to prodectbusbar with many input
and outputs
Is This Answer Correct ? | 5 Yes | 5 No |
Post New Answer View All Answers
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
When color of silica gel will gets change from blue to pink from Top to bottom?
what is differentila pilot supervision in the incomer control panel in the power station?
when we decide to use soft starter drive or vfd drive in mcc to operate apump?
what is the earth current,reverse power,electrical trip generator short circuit,low voltage, high voltage please discribe me
What is proportional controller?
What is the formula for selecting the cabels according to load? How to calculate what sq.mm cabel to be used?
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
ratings of lightning arrester
do we use neutral grounding for resistive balanced load? if we use what happen?
how we explain parallel paths armature winding?
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
What is effect of harmonic current (Draw by VFD) on power system/ electrical Equipments ?
what is advertised hop count