what is different between cisco router and layer 3 switch
- 8 Answers
- 14758 Views
- Cisco, LABA Nepal, I also Faced
- E-Mail Answers
Answer Posted / rohan
1.)THE ROUTER MUST BE PLACED IN THE WAN MINIPORT POSITION.
2.)MAKE THE WIFI IS RESEMBLE THE ROUTER IN A POSITION THAT
A LASER BEAM IS SUPPOSED TO REAC THE LAN SEETINGS
3.)MAKE THE SEETINGS OF ROUTER AS IT IS CONNECTED.
4.)JUST ENABLE THE SEETINGS THAT WE CAN CONNECTED IT
PROPERLY UNDER DISGUISTE CONDITIONS THAT A COMPUTER CAN
WORK MORE COMFOTABELY
| Is This Answer Correct ? | 2 Yes | 6 No |
Post New Answer View All Answers
Explain how many collision domains are in switch?
What is the difference between the switch, hub, and router?
Explain what is route poisoning?
What is the draw back of ospf protocol?
Explain protocol?
What does vlan provide?
What is icmp protocol?
What is loop back ip in ipv6?
Which cable called v.35?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
What is topology in ccna?
Why we use debug command?
What are the ranges for the private ips?
Can you explain the broader steps of how L2F establishes the tunnel?
In port based access-list which command you give instead of ip?
