Interested to Buy Any Domain ? << Click Here >> for more details...
why hv winding is not placed near to transformer core
- 4 Answers
- 25430 Views
- I also Faced
- E-Mail Answers
Answer Posted / raghavendran.r
One of the reason for that is the practical difficulty in
the arrangement of the Tap Changer, because Tap changer is
placed on HT side for voltage adjustment.
Also the insulation between the Core and the HT winding
has to be thick to withstand the stress.So the size of the
arrangement will be more bulkier.
| Is This Answer Correct ? | 34 Yes | 8 No |
Post New Answer View All Answers
Why derivative controller is not used in control systems?
how much LT load can bear by the 100 KW HT connection.
What Normal(Tangent) towers and Tension(Cut-point) Towers?
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
A 2083kva AVR was tested, phase to ground shows continuity, what is the implications
Write the programming software name for LG, SIEMENS,Messung,AB
Formulae for calculating the transmission line losses for different voltage levels
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
What is minimum permicible value of leackage current for LT Panle when applying voltage up to 3 KV for 5 Minuits?
why do we carry out winding resistance test?
WHY BREAKER ARE USED IN SUBSTATIONS?
why ups rating in kva? and why ups are in parellel?.why isolation transformer is used in ups?
direction of tarbine& genrator
What is inverse definite minimum time lag relay? Where is it use?
What is a commutator?
