Interested to Buy Any Domain ? << Click Here >> for more details...
What is C check in a diesel generator and what are parts
and what has to be done during the C check
- 4 Answers
- 19116 Views
- I also Faced
- E-Mail Answers
Answer Posted / sathish n p
C check is carried out along with A & B ,
B checks
Coolant level
Oil filter replacement.
Fuel filetr replacement.
Alernator terminals tightness checking.
Replacement of lubricating oil....etc
C checks.
Coolant level replacement.
Check the fuel injectors etc..
Its depends on the size of the DG sets , auxillary
system,freuency of mainttenance ...
| Is This Answer Correct ? | 18 Yes | 2 No |
Post New Answer View All Answers
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?
HOW TO CALCULATE EARTHING SIZING?
why we use Test Terminal Block in 11 KV and 33 KV electrical panels.
on a three-winding transformer relationship delta-delta-star, on third winding why the relationship is a star? what are the advantages and disadvantages? Thank you and please help
What technology is used in latest generators?
importance of reactive power management
What is the estimated total hydropower potential of india?
whether starting current is limited to rated current of motor through soft starting or it exceeds the rated current?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
Enlist four components of electrive drives.
how to compare with Relay settings for HT< panels, RMU panel, and PSS CSS transformer?? 1) Load amps, 2)Tripping time, 3) CT ratio, 4)Cable size 5) Transformer KVA rating 6) transformer full load amps
what is ratio of copper wire size and current ?
How to test IR testing & magnetic balance test
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
