Answer Posted / s vedpathak
There are different types of level transmitter who works on
different principle exa Displacement type,differential
pressure type,nucleonic type,capacitance type etc.
Displacement type L Tx works on Archimedes principle which
states that the buoyant force on a submerged object is
equal to the weight of the fluid that is displaced by the
object.
similarly in D/P L tx, fluid exerts pressure on HP/LP side
of the capsule & based on the differential head & specific
gravity, the transmitter gives mA output.
| Is This Answer Correct ? | 30 Yes | 8 No |
Post New Answer View All Answers
What you mean by multi stage control vavles?
how can we tune a PID. If it is by zeiger nichols method..please explain briefly with help of an example.
how do we commission inergen system?
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
WHAT IS TMXT IN TEMPERATURE FOUNDATION FIELDBUS.
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
What is the diffrence between digital signal processing and discrete signal processing?
i want formula for flow control.am doing project in flow control using orifice . i know value of the flow level(Q) . upstream(p1) pressure, orifice diameter(Do) , pipe diameter(Di) and oil viscosity(Vi) how can i calculate downstream pressure
you are on site,the plant trips,you are approached by operations,what do you do?
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
Explain an adaptive / self-tuning controller’s major draw card.
How to change dcs card in online. (Dsc is maxdna)
why is an oxygen sensor used in a boiler stack
