Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / siva
since the losses in the transformer is iron and copper loss
which depend upon the voltage and current but not on the
angle between them
| Is This Answer Correct ? | 25 Yes | 1 No |
Post New Answer View All Answers
what is strip power factor?
Why reactors use before incoming of ac vvfd drive?
Mention how NPN and PNP transistor works?
We have 90mX100m hangar with 16 no.of supporting pillar. It is required to provide power supply on all pillars. what is suggested earthing scheme for hangars.
Why do power lines not short out when they fall into water?
How we calculate the current carrying capacity of H.T. cabel?
What is Electrical Grade Aluminum for Tubular BusBars. i am confused between 6063 and T6 or T5 and what is BS 2898 and BS 159?
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
whit is 33kv power 300*300 cable full current with formula
In both 600/1000 V cable and 450/750 V cable, we can supply 415 V. However for distribution, all utilities are using only 600/100 V instead of 450/750 V. What is the reason?
How much earthing frequency is capable?
we have a lot of model of rectifier but thyristor rectifier is the most rectifier that use in power system. Do you know why this rectifier is used?
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
EHV current carrying parts need to have smooth finish,then how can a 245kv GIS with emery finish can run so long?
Is any AC drive(VFD) had a feature of DC injection braking? if available please mention the detail. i.e drive can supply braking torque when the motor in idle state.
