What is C.T, why it is used and what care should be taken
for that while connecting?
Answer Posted / aee_rt
C.T. is current transformer, its similar to Transformer bur
is made for low burden(i.e load).It is used to step down
the current level in order to use it for measurement and
for providing protection, coz current in terms of kilovolt
cannot be measured.Its seconadary output is fixed at 1A or
5A. Its manufactured for particular ratios and its
secondary current is proportional to primary current.
When its connected in circuit, please be sure that none of
secondary terminals are open n check for its insulation
resistance.
| Is This Answer Correct ? | 19 Yes | 4 No |
Post New Answer View All Answers
What are the basic properties of signal flow graph?
block diagram of 2 ups system connected in hot stand by mode?
What is meaning of out of phase (making & breaking) capacity And how to calculate
I am shobana from Chennai. I am having my personal interview on 19th Dec at Chennai.kindly mail me the questions to mail id shobana.shanthi@gmail.com
Give the expression for the frequency of oscillations in an op-amp sine wave oscillator?
where is the need for short circuit test for 3 see is required and why? can you explain in brief with application
advantages and disadvantages of inverse definite minimum time RELAY
what is the difference between single ratio, multiple core and multiple ratio, multiple core ? please explain.
Why open circuit test of transformers is conducted at rated voltage??Why not any other voltage??
What is 100% protection of generator? Why 100% is not used but 95% is generally used?
What OPGW is better than Microwave or PLCC???
Define coil span?
When we connect the large capacitor bank in series ?
what is plunger and what's the use of it in motor alignment?
when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.