Answer Posted / ashish
There are 8 Run Level's in Solaris.
S, s
Single user mode. Doesn't require properly
formated /etc/inittab. Filesystems required for basic
system operation are mounted.
0
Go into firmware (sparc)
1
System Administrator mode. All local filesystems are
mounted. Small set of essential system processes are
running. Also a single user mode.
2
Put the system in multi-user mode. All multi-user
environment terminal processes and daemons are spawned.
3
Extend multi-user mode by making local resources available
over the network.
4
Is available to be defined as an alternative multi-user
environment configuration. It is not necessary for system
operation and is usually not used.
5
Shut the machine down so that it is safe to remove the
power. Have the machine remove power, if possible.
6
Reboot
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
After first installation of Solaris 10, what and all the Securities We need to set and how ?
Write the steps involved in creating and executing a program to implement the “case” command.
Which command is used to backup and restore solaris file system?
How to configure email notification in solaris 8? We are using netbackup 5
please post step by step installation of packages from the EIS cd..
How to add a new LUN in exit disksets (metasets) in solaris please answer me step by step procedure?
What does pkgadd command do?
what is the difference between solaris8 and solaris9 and solaris10
Hi We have upgraded our sun machine from solaris 9 to solaris 10. Before upgradation the date command output(Solaris 9) Wed Oct 13 09:45:21 IST 2010 But after upgradation the output for date is as below(solaris 10). Wednesday, October 13, 2010 9:46:14 AM IST Looks like I need to change LC_TIME=C. can you please help me how to change it for permanently
Where do you get Alarm prompt?
what are the alarms in solaris?
There are two nic cards on a sun server. I need to connect one nic to pupic ip and another nic to DMZ. Could you tell me how to configure step by step?
How can u find a file which is logged in last week?
How to make SUN server as router in subnetwork?
What are the differences between the command line and graphical user interface?
