Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / vinnu
transformer is a electrical machine which convert the
voltage level with corresponding changed in current means
the power will be constant,it works on the principle of
mutual inductance,the rating of transformer is always shows
in KVA.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
can a 150 kva 3 phase 440v/230V delta-wye step down transformer can be use as step up transfoermer with connected loads at 440v side?
how much allowable resistance that can be difference in motor all coils?
how much flux density of CRNO core
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
what is the soft starter principle? how is connection diagram? what is the procedure for checking the connection?
what is PDU in transformer?? which company manufacture??
What is the rate of WCT on the Electrical Contracts comprising of DG Sets and Civil Works in Delhi ?
DEAR SIR/MADAM,CLEARLY EXPLAIN ABOUT CRAWLING AND COGGING EFFECTS IN INDUCTION MOTOR.
What is the meaning of floating point earthing in battery backed systems ?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
how technical is calculated in 11kv line and lt line
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
in indoor type circuit breakers why only the corner breaker trips specially during cold season. What is the reason.
