Interested to Buy Any Domain ? << Click Here >> for more details...
How much voltage we get between two wire of 4 to 20 ma
output? Is this voltage up or down respectvice to 4 - 20
ma ?
- 9 Answers
- 14747 Views
- I also Faced
- E-Mail Answers
Answer Posted / ajay ugale
if we r using 250ohm resistor in parallel with the signal
we will get 1-5Volt DC i.e at 4ma we will get 1 volt and at
20 ma we will get 5 Volt.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
what is span value and zero ? and how set ?
What is Positive Calibration and Negative Calibration?
What is loop1 and loop2 in MTS LT?
what is the procedure of belt scale calibration?
Give Detail information about plc,dcs,and scada system?
How d.p. Transmitter can be applied to close tank?
tell me the field & lab calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter, temperature transmitter, temperature indicator, flow indicator, level indicator, control valve, thermocouple, pressure indicator (digital & analogue),
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
Basically iam Instruemntation Engineer, but Iam interested in Instruments design engineering, so plz guide, is there any course, training or Softwres to become Instrument design engineer??.
What is limitation of the ht.of the displacer of a level trol?
how many type conductivity sensor ?
Sir,I am going to sit for IOCL written test exam. recently.Can anyone tell me the name of 'Objective type Question Book on Instrumentation Engineering ' which will help me. Pl. mail to bidyut_71@rediffmail.com / bidyut.saha2008@indiatimes.com / bidyut.saha09@yahoo.in
Draw a great bridge circuit.
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
