I am facing one problem in my layer 2 switch I don’t know
the problem is on switch side or client side. The problem is
some PC (not all) are stop participate in LAN they don’t
send or recd. Packet from switch and if I check RJ45 (with
LAN tester)from PC side the packet and 8 pin wire is working
fine and after that process of LAN tester I plug RJ 45 in PC
now PC start recd/ send packets what is the problem I don’t
understand even client side no virus found RJ45 is ok and
switch has no problem bcoz other PC is working fine Cable
(cat 5 ) is also fine bcoz I didn’t crimp again just check
in LAN tester and start working fine. Plz any one solve this
matter. And after lan tester process pc is working fine and
after 2 or 3 hour it again start same problem and again same
process lan tester I have used
- 5 Answers
- 6694 Views
- I also Faced
- E-Mail Answers
Answer Posted / sunil
check that there is not an lose contact.or reinstall the lan
driver
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
When we do default route?
Explain how many types of ips?
Explain the terms unicast, multicast, broadcast and multicast.
What is hsrp?
Which command we use for ping in ipv6?
What is the simplest way to remotely configure a router?
What is the size of hello packets in eigrep protocol?
What is the difference between private ip and public ip?
What is hold down time formula of ospf?
What is the difference between unicast, multicast, broadcast, and anycast?
What is default cost of serial interface in ospf?
What are the ranges of private ips?
What is the difference between an igp and an egp?
What is difference between igp and eigrp?
Why ip address called logical address?
