I am facing one problem in my layer 2 switch I don’t know
the problem is on switch side or client side. The problem is
some PC (not all) are stop participate in LAN they don’t
send or recd. Packet from switch and if I check RJ45 (with
LAN tester)from PC side the packet and 8 pin wire is working
fine and after that process of LAN tester I plug RJ 45 in PC
now PC start recd/ send packets what is the problem I don’t
understand even client side no virus found RJ45 is ok and
switch has no problem bcoz other PC is working fine Cable
(cat 5 ) is also fine bcoz I didn’t crimp again just check
in LAN tester and start working fine. Plz any one solve this
matter. And after lan tester process pc is working fine and
after 2 or 3 hour it again start same problem and again same
process lan tester I have used
- 5 Answers
- 6693 Views
- I also Faced
- E-Mail Answers
Answer Posted / lokesh
reset the network adaptor for partular system
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Explain what is overlaod?
what is Bandwidth capping
What is the difference between the switch, hub, and router?
What is etherchannel?
What are the types of resource sharing?
What is segmentation and fragmentation?
Can yo define LNS
Mention what command you must use if you want to delete or remove the configuration data that is stored in the nvram?
What are the advantages of layered model in networking industry?
What’s the easiest way to remotely configure a router?
What is the difference between switch, routers, and hub?
In how many ways you can access router?
Tell me which cable we connect in db-9?
What is the difference among straight cable, cross cable and rollover cable?
What is the logical link control?
