Lap length may different for FE 415 and FE 500 Steel, If
different what is the different, In which code is mentioned
- 3 Answers
- 17406 Views
- Bestech, I also Faced
- E-Mail Answers
Answer Posted / gurusharan
Laping length is different due the tensile strength of both
is not equal.
| Is This Answer Correct ? | 15 Yes | 9 No |
Post New Answer View All Answers
What is the use of water table & Kreb stone for drain
it is possiblee to produce concrete with out cracks...
what is the cost difference of a same structure when it is constructed with brick masonary and when it is constructed with block masonary and concrete as a frame structure????????????????????????
punj loyed and sapurjl palanjl
how to determine H- zone in a column? where it will occur?
Which code specifies the specification ofthe construction joints to be provided in the raft slab of a basement which is 6 m deep.what should bethe detail of such a joint?
How much cement and sand required for 9"brick wall per square metre
How much of fly ash is allowable in Portland cement and what is the disadvantage when the level of fly ash is increased?
Thumb rule for steel qty for 1m2 in kg/m2 column slab footing beam
why does the most of civil engg is not intersted to going for teaching field?
A rock anchor 3 1/2” in diameter is placed in rock. The which has an allowable shear strength of 1200 psi. Determine the required anchorage length to safely carry a 80 ton load using a 2.0:1 F.S
manhole chamber having height of 2300 mm and thickness of brickwork is 230 mm and dia of opening covering is 560 mm and bottom length vertical is 1500 mm (1:4) brick masonry and plaster 12 mm on both sides..how to estimate the no bricks used with mortar cement bags and sand for total chamber including plaster.
a solid steel rod length 2m dia and 20mm vertically hangs from celling and has a collar firmly atteched to it. above the collar an annular rubber washer of 40mm th. having stifness k = 5n/mm is placed. determine maximum stress in the rod caused by mass of 5 kg falling through a height of 1.2m.
1) What is meant by C-soil in geotechnical Engineering? 2) What is Eve board? 3) What will happen when heat is applied to cement? 4) what do you understand by the lateral dimention ?
What is the standard volume of pharma in cub ft
