Interested to Buy Any Domain ? << Click Here >> for more details...
how to set the overload setting in the thermal overload
relay?? is there any calculation in that??
- 3 Answers
- 17780 Views
- I also Faced
- E-Mail Answers
Answer Posted / balasubramaniyan.t
Overload setting in the thermal overload relay to be done based on the motor full load current.The setting current of the relay should not exceed the motor FLC.
| Is This Answer Correct ? | 12 Yes | 7 No |
Post New Answer View All Answers
What is the capacitance values of 132,220,400 & 765 kV current transformer
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch
what's the simultenous maximum demand (SMD)..what the diffrent MD and SMD?
What is voltage ratio of a transformer?
what is the main function of capacitors in mccs.
how to changeover ups in this power failur time?
how electrical earthing maintenance done in industry?
How to calculate per unit impedance of transformer?
how to put cable sizing and cable glands size for respective cable & Cable Lug size in a DB sectors???
What will happen if the armature resistance is in minimum position and the field resistance is in maximum position while starting the motor
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket
Why is a plain induction motor unsuitable for wide speed control?
What is the Resposiblity of Electrical Utility Engineer
why constant voltage transformer should be start without load? and if started then what will happen?
