We are using Powerica make 100 KVA DG set. Whenever i
connect compressor on DG load (Compressor Make Atlas Copco
5.5 kva) that time we face the lot of fluctuation on Dg
output. Can you please suggest me how can prevent this
fluctuation?
- 6 Answers
- 9817 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajju
Kindly check the other loads that u r connected because
there may max demand problem
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
how to check regenerative load in drived motor
explain all the classes with example
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
What is instrumental error?
Where is servomechanism used?
What is transformation ratio what it describes?
how we can decide that what value of ht line will come to any commercial building? (ans except According to the building load)
HOW TO CALCULATE ELECTRICAL, MECHANICAL,& OVERALL EFICIENCY OF GAS ENGINE POWER PLANT
Name two low frequency oscillators?
Which type of transformer is used for lighting loads?
What are the types of control system?
How does an oscillator differ from an amplifier?
How to check the Bushings of the transformer?
why and where we use early make & late break contacts in protection?
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
