Interested to Buy Any Domain ? << Click Here >> for more details...
I am facing one problem in my layer 2 switch I don’t know
the problem is on switch side or client side. The problem is
some PC (not all) are stop participate in LAN they don’t
send or recd. Packet from switch and if I check RJ45 (with
LAN tester)from PC side the packet and 8 pin wire is working
fine and after that process of LAN tester I plug RJ 45 in PC
now PC start recd/ send packets what is the problem I don’t
understand even client side no virus found RJ45 is ok and
switch has no problem bcoz other PC is working fine Cable
(cat 5 ) is also fine bcoz I didn’t crimp again just check
in LAN tester and start working fine. Plz any one solve this
matter. And after lan tester process pc is working fine and
after 2 or 3 hour it again start same problem and again same
process lan tester I have used
- 5 Answers
- 8109 Views
- I also Faced
- E-Mail Answers
Answer Posted / premkumar
can u check whether its DHCP or Static ip Address?
If its static means change in dhcp. try this.
| Is This Answer Correct ? | 11 Yes | 7 No |
Post New Answer View All Answers
Wild card mask always in odd value or even?
what does the clock rate do?
Explain what is the size of hello packets in eigrep protocol?
Explain the draw back of ospf protocol?
What do you understand by poe (power over ethernet)?
What is hold down time formula of ospf?
What requirements should a VPN fulfill?
What is Route Poisoning?
What does the show protocol display?
what is the difference between a ‘half-duplex’ and a ‘full-duplex’ system?
Can you explain tunneling?
Can you explain PPP link process step by step?
Define load balancing?
What is the difference between arp and rarp?
Can you explain static and dynamic tunnels?
