Interested to Buy Any Domain ? << Click Here >> for more details...
We are using Powerica make 100 KVA DG set. Whenever i
connect compressor on DG load (Compressor Make Atlas Copco
5.5 kva) that time we face the lot of fluctuation on Dg
output. Can you please suggest me how can prevent this
fluctuation?
- 6 Answers
- 11731 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajesh
Dear sir,
5.5kva Around (5kw) Capacity is very low
capacity compared to your generator you just calculate
other power usages And load .
If u feel compressor is a only problem you can minimize
other load and start the compressor for testing you can get
conclusion for this issue
| Is This Answer Correct ? | 7 Yes | 6 No |
Post New Answer View All Answers
how to calculate energy of 3-phase motor?
What is the ratio of true power to apparent power in an ac circuit?
Could the power factor on electrical system can affect the registration of the kwhr meter or the CT/PT?
importance of reactive power management
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
what the principle of sincroscope?how it works?when it needed?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
why does make gain margin and phase margin on same plot.?
i want to know about torque of slip ring induction motor
what percent do you derate your copper wire when you change from copper buss to copper wire
how can see the ac indoor or out door ac which Tr
How to Decide the Location of Earth pit for Compressor in Oil Depo? and How to measure the resistance of earth pit Pls explain me with the help of Circuit Diagram?
What is accuracy of a measurement?
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
how to calculate cable size in diffrent loads?
