Interested to Buy Any Domain ? << Click Here >> for more details...
Can we operate a DG Set in paralell with Transformer ?
- 6 Answers
- 13921 Views
- NDDB, Sobha Developers, I also Faced
- E-Mail Answers
Answer Posted / a. venkatesh
All the power source it may be transformer or Alternator
(DG-DC power generator).
For parellel operation synchronisation is important. I.E
Voltage level, frequency, phase angle should be equal for
the both sources.
For checking the synchronisation previously DARK LAMP
METHOD was used. Now a days special relays used for this
purpose. Relays MES 120(Schneider), 7UT relays in Siemens.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is the use of mc( moving coil) in dc voltmeter and dc ammter and what is the use of ( moving iron)in ac voltmeter nd ac ammeter
What is turn ratio of a transformer?
How wire size can define in electrical wiring? What is the ratio?
In a large office how do we calculate required number of light fittings, assuming fittings are 4x18W or 2x36W fluorescent fitting ?
Why does the radius of armature is less than the radius of pole shoe?
What is the need of generator relay panel
why the protection turbo generators is most complex?
why using transformer and thyristor switch in 3 phase apfc panel
which motor have relatively high power factor and what is reason for have high pf? 1.capacitor run motor 2.shaded pole motor 3.capacitor start motor 4.split phase motor
how to select overload-relay for perticular motor 1.for D.O.L. starter 2. for Star-delta starter ????
If a transformer primary winding operates at 240v, the secondary at 120v and the load is 1500w & the transformer is rated at 92% efficient, what's the current flowing through the primary winding of the transformer? What is the formula for finding this?
What is core CT & it's function?
Draw the circuit of clapp oscillator?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
wat is the first thing dat is needed, 2 lay a cable in some area??
