Interested to Buy Any Domain ? << Click Here >> for more details...
I have a thermal flask in which i have to fill the boiled
water.
I also have thermocol, saw dust and silver paper.
Now tell me how i have to arrange these material to attain
minimum
heat loss.
- 7 Answers
- 9202 Views
- I also Faced
- E-Mail Answers
Answer Posted / manikandan
1.Thermal flask,
2.Saw dust,
3.Thermocol,
I think there is no need of silver paper. But as per your
question it cn be used as the last.
Saw dust should be used next to your thermal flask because
it can be tightly packed without air gap than thermocol.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
How i injecter setting qsk series cummins engine and i can using click type torqurench or dial gauge type
Hai, iam renjith. my qtn about the calorex heat and cool pump. What is the reason of the above machine is trip on high pressure. r134a gas using in this system. 8 months old. model is calorex propac 90(3 phase). This system has 2 compressor. Both are starting on 13amps after that rise up to around 21 within 1 minute. After will be trip on high pressure. Showing 68 psi in suction side on standby mode. Can i have a solution without delay? Renjith renjithngm@gmail.com
What is the differenc between total moisture and inherent moisture in coal ?
Dfine the density of plastic?
what will happen if outlet of electric pump is closed though pump is running?
state the microstructure of annealed and normalized
What is the cause of cylindrical liner overheating?
Why must we pay attention when we drain steam in steam turbine. What factors are observed?
What is gtsc technology?
as started in the job offer notification, is our basic salary of 1lakh good for you if employed?
Explain the difference between afbc, bfbc, pfbc and pcfb in regard to fluidised bed technologies.
Is there a metal that does not contain iron?
What is the difference between a mechanical engineer & a Marine engneer?
State the laws of thermodynamics and its importance of in mechanical engineering.
Give an example of a time when you had to explain some new procedures to your co-workers for quality service delivery. How did you go about it?
