Interested to Buy Any Domain ? << Click Here >> for more details...
Resistor switching is used in which type Circuit Breaker
?
a) oil filled CB b) Air blast CB c) Gas filled CB
- 11 Answers
- 31439 Views
- Engineers India Limited, wbsedcl, I also Faced
- E-Mail Answers
Answer Posted / rajdeep
its air blast circuit breaker.........but resistance
switching is not used..it is one kind of disadvantage.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
how is the magnetic current test is different in delta-star and delta delta transformer.
How phase to phase voltage comes 440V.
What is effect on in zone and out zone fault if CT chosen for phase side is Vk/2<5mA and Neutral side is Vk/2<15mA on REF protection of Transformer
What is big transformer parts and their function ? Ty
how to test YNyn0 vector group in transformer?
In india, according to trade theory above 5 HP motor reqired star delta starter. But we R connect 11 KV motor with 14MW in Direct to line ( With VCB starter combination) Can U Guess, How it is possible ?????
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
What is meant by positive and negative feedback?
Please explain me about Relay curves and their sources to read ?
how a resistor resists to flow the current?how an inductor oppses the sudden change in current?how a capacitor opposes a DC voltage.
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
Can 33kva/415v transformer be run underground? If the answer is yes why and if the answer is no why?
what is mean by drives?
