Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / prashant sharma
power factor is simply the angle(phase) diffrence b/w the
voltage and current wave in a system.
in case of d.c. voltage, as it is not a fluctuating wave,
the resulting current is also non fluctuating. thus no
phase angle exists b/w them.
| Is This Answer Correct ? | 22 Yes | 0 No |
Post New Answer View All Answers
how to avoid electrical shock how capacitor store charges wat are the speed control of induction motors state faradays law flemings left hand rule what is rotary converter wat is transmission and distribution what are the sources of energy abrevation of acb,vcb,sf6,igbt what is output equation of transformer which test copper iron and iron loss are calculated what is eddy current draw a single line diagram (10 marks) draw direct online starter(10 marks)
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
After completing iti in electrician, how can i get certificate of electrical supervisor? What ia requirements. For it?
How to calculate KVA/VA rating of PT or CT from primary & secondary voltage or primary & secondary current?
What is purpose of reactor?.What is different between line and bus reactor?
Why you want to join non technical field when you are an engineer?
I am doing apprenticeship training at HT switch yard in NLC. How can i get electrical c license. ??? What r the rules for getting it as an apprentice? ??
how you configure motorvision relay (L&T make)from DCS
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
Sir, I have applied for the of Assistant.engineer of NPDCL. please send me all AP TRANSCO AND JENCO solved papers of previous exams . I requested send me the papers to my id as soon as possible (rajanikanth_peddi@yahoo.co.in) (This is very urgent) Thank You,
physical identification of HT & LT panel
What is EHT tariff or Power factor Tariff ????
Why 11kv to be generated in generation station
