Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / praveen
Tan Delta, also called Loss Angle or Dissipation Factor testing, is a diagnostic method of testing cables to determine the quality of the cable insulation.In a perfect capacitor, the voltage and current are phase shifted 90 degrees and the current through the insulation is capacitive. If there are impurities in the insulation the resistance of the insulation decreases, resulting in an increase in resistive current through the insulation. It is no longer a perfect capacitor. The current and voltage will no longer be shifted 90 degrees. It will be something less than 90 degrees. The extent to which the phase shift is less than 90 degrees is indicative of the level of insulation contamination, hence quality/reliability. This “Loss Angle” is measured and analyzed.
| Is This Answer Correct ? | 10 Yes | 2 No |
Post New Answer View All Answers
what type of motor used to move a 1 ton gate? and relate ratings with load.
why on axial hitting up of air blast on hydrogen produced in oil circuit breaker,temperature rises of the core of the arc?
why 5kW motor becomes unbalance if its relay trip 1st time and its set value is 7.0 A
Dear Sir/Madam, I have one questions we have three steam turbines and one Gas turbine and our industry linked with the public network, we have protection system one of the protection is reverse power we can export just four MW only i would like to ask about how to calculate the reverse power. Thank you in advance best regards
What is the current carrying capacity of 0SWG,3SWG,10 & 12 SWG solid bare overhead copper conductors?
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
Is it possible to connect a safety device in to parallel?
what are symmetrical and non symmetrical components in electrical installation.
How we can change the direction of rotation of Induction motor? Prove it using graphical
defination of lines
How to design inductive load for 3 phase 440v and maximum 5 amps for star or delta? Can we use a 15kW, 1450rpm motor for 15kW, 960rpm apllication?If yes.how......n.if thesame motor used what`s it`s sideeefect.
A low wet bulb temperature indicates
The electromagnetic torque developed is proportional to what in a D.C series motor?
how you taken aotitude test
what is negative d.c. voltage, why this voltage is used in base transciever station.
