Interested to Buy Any Domain ? << Click Here >> for more details...
how can u increase the efficiency of power plant without
changeing in effort?
- 21 Answers
- 29822 Views
- BARC, I also Faced
- E-Mail Answers
Answer Posted / shiva
Efficiency of the Power plant can be increased by reducing
the heat losses occurring at different systems of the power
plant. The Boiler has heat loss, the heat is lost in the
Economiser, the heat is lost in the Air Pre heater and
ESP.In additon to this there is heat in the chimney taken
away by the flue gases. Hence by reducing these losses, the
efficiency of the power plant can be improved.
Since Efficiency
= Output(steam Geneartion)/Input(Heat in the Fuel)
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
i am appearing for the interview of the company SANDVIK??so if u can send me some questions or suggestions on how to prepare,it would be of great help to me.u can send the above at ekjain@yahoo.co.in.thanking you.
What are you going to inspect or check when you open the crankcase?
how can i replace annular plats in tanks
What are different types of gate valves?
why the head portion of the screw jack (which carries the load when not rotating) is made hollow?
1.how do you purchase the sheetmetal,machined components for OEMS? 2.WHAT IS THE SYSTEM TO BE MAINTAINE FOR PURCHASE ACTIVITY? 3.HOW DO U DO THE PRICE NEGOTIATIONS & ITS PROCEDURES? 4.WHAT ARE THE PROBLEMS WILL FACE WHILE PURCHASING THE COMPONENTS& WHAT IS THE SOLUTION TO OVERCOME BY THAT ONE 5.WHAT IS THE NECESSARY NOTES TO MAINTAIN THE PO& RELEASING THE PO?
Explain how the cylinder lubrication on main engine is done?
tell me about a time when u had too many things to do and u were required opinion prioritized your talks
Explain what are the thermal conductivity properties of brass?
Find the greatest and smallest number among the given 5 numbers without using ‘>’ or ‘<’ operators
Why is stress considered important in a shaft?
sir i need section engineer test papers
If mft not act when spark failure 3 time what problem will happen in boiler side
Is copper tube withstand under hard water say as 500 TDS.And is it cleanable by solfamric acid or by tube brushing
The lowest allowable insulation resistance?
