in thermal overload relay class 10A indicate what
Answer Posted / jothiswaran.s
Adding to Mr Paul , the class of relay indicated the error
percent. usually matched with the CT. also they will not be
marked as "class 10A"
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
what is the requirement regarding earthing of Single conductor with AWA
What are the different types of dams?
What is the type of feedback used in an op- amp schmitt trigger?
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
xfhnchncv?
where we use the SFU & FSU?
Define sensitivity?
Is a d.c.compound motor is use as a booster? how?
I want to know all basics of electrical engineering
how we do Vector group ,magnetic balance and tap changer test in Transformer?
How one may guess the direction from which the distribution line is incoming if there is no pole plate on poles?
What is domestic transformer? Draw the connection of domestic transformer.
How to calculate the heat load for a electrical room
An automatic water heater is an example of which type of control system?