Interested to Buy Any Domain ? << Click Here >> for more details...
How the starter control the starting current in three
phase AC Motor?(In DC apply the reistance).
- 6 Answers
- 16098 Views
- I also Faced
- E-Mail Answers
Answer Posted / venu
Mainly starters are used to reduse the starting
current.normally we will use the star delta starter for the
above 7.5HP.
as per the electrical formula.
motor will start in star first
since IL = IPh
coz we have to equilize the starting current
then its go to delta
Since VL= Vph
Finally
In star -Current equal
In Delta- Voltage equal
that how the starter will control the startingcurrent
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
for compensate 315mh inductance ,how many capaciance required?
WHAT IS LOAD CELL
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
differnce between single acting and double acting solenoid valves
state basic meaning of 'INDUSTIAL AUTOMATION'?
ht side line to earth voltage
-What should be minimum value of insulation resistance and maximum value of earth resistance at any electrical instillation and what is method of testing the same.
33kv Rated output avilable in market (any where in india)
How to improve fuel cell in a distribution system?
what is the constructional difference between a power transformer and potentian transformer?
If we have to feed a housing complex having load 8MVA, than what would be the better option, either we first step down 33kv supply into 11kv & than 430v or we proposed no of 33/.44 kv transformer, also which option is economical?
The transmission does not have options: a)Partition noise b) Flicker noise c) resistance d) Short noise and reason
what is breathing?
what is the total power generation in india?
