Interested to Buy Any Domain ? << Click Here >> for more details...
11 kv metering is done in my factory.Meter show PF 1.000
but kvarh lag&lead show 24&94 respectively & Avg.PF
is .956 .? is what i do for inproove my PF to 1.000
- 3 Answers
- 5731 Views
- I also Faced
- E-Mail Answers
Answer Posted / arvind
it is very difficult to achive 1 power factor because it
depends on the load. as u said it is 0.956, then it is good
that power factor is almost to 1.
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
What is meant by reactance voltage?
What is the purpose of stand by earth fault protection for transformer ?
IN dc capacitive reactance is??
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
DERIVE AN EXPREION FOR MAXIMUM POER TRANSMISSION, WHAT ARE ITS APPLICATIONS.
How can I known multiplying factor .without multiplying table
why the NGR (neutral grounding resistor) always OFF during DG off?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
why does the magnetic balance tests at transformer?
Define what is the function of anti-pumping in circuit breaker?
what is ground fault in ACB?
which protection function should measure RMS value of current&DFT value of current?
Why we cant store an ac power. If we coo store in which device we can?
